The idea with a kind of drop point style is quite good. My intention is to cut off as little as possible and not to make the point too round. For...
Thanks for the tip with Jasco. I will try to get it in Germany for the next knife (Esee 5).
One thing is taking hold of me: the bent tip. Every time I am looking on the blade, I am not satisfied with it. I think I will cut it off....
Unfortunately I made only little progress with the Junglas 2. I just stripped it with a paint remover for wood. I had to put it for 16 hours in...
My first Junglas. So proud. Thanks @Twoody88. [ATTACH] [ATTACH] I just etched the Logo and then I blued it. What a beauty.
:) Thank you !
Did it break?
Thanks for your answers. I think I will leave it as it is. If I will dislike it too much in the future, I can try to change it later.
There is one thing about the blade, that is causing a little headache. The tip of the blade is a little bent. I would be thankful for your advice....
So, the etching job is done. Deep enough I hope. Let’s see after the paint removal… So far I am very happy about the result. Never thought I...
Many many thanks to you! I can fully return your positive words. In general it was very nice, that you were willing to sell to Germany. Everything...
Filling some minor scratches with paint to protect it from the acid. Now I can go on with that extremely cool logo ;). [ATTACH]
After applying and cleaning it approximately 15 times and letting the acid work for 30 minutes each time, it is looking like that. [ATTACH] For...
Actually I am just applying it only on the surfaces that I want to etch. [ATTACH]
Because I have no experience with acid etching, my first steps are marked by being very carefully. After the advice from Drew RedBear (many...
Very good idea.
Until now I didn’t etch the logo. I only was working with some needles and tried to scratch the dirt and corrosion out of the lines. Cleaning with...
After some hours of reshaping the logo, it looks like this. [ATTACH]
No, the knife wasn’t etched by the previous owner. I like the skull logo, so I try to save it with the help of etching. After that I will remove...
Thanks, I hope that I will get it done. It is really hard work to get the skull logo in a shape that will allow to etch it. We will see… Some...