ESEE-6 Sheathing                              

 

The following accessories will fit ESEE-6 knives. Mounting hardware included.

International orders must contact orders@eseeknives.com before ordering to verify shipping costs.

 


 

 
 

 
 

 

                                              

             ESEE-6 Molded Sheath                                                                                     MOLLE Locks

  

                                                    

             ESEE-6 Clip Plate                                                                                                  ESEE-6 Accessory Pouch

  

ESEE-6 MOLLE Back

To attach the MOLLE Back, simply align the holes in the lower portion with the holes in the sheath and use the four screws and posts provided to securely fasten the MOLLE back to the sheath. The top of the MOLLE back has both an adjustable handle retention strap and a flap that can be slipped over the pommel end of the knife and secured tight with the paracord and cord lock, making the ESEE-6 sheath jump safe. Both the top portion and lower portion of the MOLLE back have a built in belt loop and have MOLLE straps compatible with the military and PALS system.

The top portion of the MOLLE back can be removed from the bottom portion by unsnapping the lower MOLLE strap and threading it through the plastic ring holding the two halves of the MOLLE back together. You can then thread the strap back through an extra plastic ring (provided) before re-threading the strap through the lower cross straps to secure it to a belt or gear again. The extra plastic ring allows you to retain the extender capability when only using the lower portion of the MOLLE back. As with any MOLLE strap system always thread the long strap under the last cross strap right above the snap to make sure the snap stays securely fastened. Failure to do so can result in unwanted release of the snap under extreme stress.

This accessory pocket will bolt to the front of the ESEE-6 hard sheath by aligning the holes in the pocket with the holes in the sheath and using the provided 4 screws and posts to securely tighten the sheath and pocket together. The screws are long enough to fasten the pocket, sheath and MOLLE back all together. This pocket will hold either the provided tin or a regular Altoids tin, as well as any other gear you can fit into the pocket. You will find many other uses for the pocket by threading paracord through the grommet holes and lashing it to your other gear or packs.